Recomendations for use and installation for LED strips (24V)
DO NOT touch or press the LED strips or other components during the installation. (1)/p>
DO NOT twist or bend the LED strip, or connection may be damaged. (2))
DO NOT connect the LED strip directly to mains supply. It must only be connected to a suitabble 24V LED driver
Avoid placing the strips in areas with high temperature or direct sunlight.
We recommend the use of aluminum profile to reduce the temperature. (Required for more than 5W/m strips).
Be aware that the products can be damaged by electrostatic discharge (ESD). Earthing is a very effective measure to avoid the damaging effects of electrostatic discharge. Therefore, a personal protection earthing system should be used during mounting to prevent the buid-up of static charge.
Depending on the surface, use a multi-purpose cleaner (e.g. isopropyl alcohol) to provide a clean and dry mounting surface which is free of oils, release coatings and dirt particles.
If the product needs to be custom cut; please measure carefully and cut at right angle by the appropiate cut marks by using a sharp scissors.
The longest distance from the converter to the strips will be given by the section of the cable to be used.
The 2V voltage drop in the conductor between the strip(s) and the converter should not be exceeded.
The section (S) in mm2 of the required cable is determined by the following formula, they are :
r the resistivity (Cu = 0,017)
L Line length in meters
I Intensity in amps
V the maximum allowable voltage drop
The converters must consider the losses in the distribution, it is advisable to oversize their power by 20% to cover these losses.