Recomendations for use and installation of bollards



For a correct conservation of the bollards / posts, we recommend their application on a raised pilaster, never at ground, or grass level. Pressure changes are caused by a change in environmental conditions and depending on the altitude where they are installed. They can be caused by a concentration of heat, produced when the luminaire is turned on and when it is cooling when it is turned off, or by a thermal shock due to rain, snow or washing cycles.

To minimize the possible condensation of water vapor inside devices with a high IP, the luminaire must be operated for 1 hour without the protective glass housing, and after that period of time, close it immediately.

All evaluations and technical decisions must be made by the person in charge of the technical department, limiting the comments or proposals made by people outside of said department.

Do not install more than one cable in each outlet.

Install on a plinth at a higher level.

Novolux Lighting